DWA-1 ,2,3,4,5 ACCESSORIES

The following accessories may be used with the dialer to optimize you security:

This is a wireless passive infrared sensor that will transmit a wireless signal to the telephone dialer whenever an intruder enters an unauthorized area. This unit detects the heat from the person as they move into the area covered. The sensor will cover an area of about 40' by 40'. Several transmitters may be used to monitor different locations. The PIR sensor operates by a 9 volt battery.

WIRELESS TEMPERATURE SENSOR

The temperature alert sensor detects a temperature drop or rise. This unit works well when used in conjunction with the dialer to monitor homes, stores, outbuildings, etc when you are away. In the event of  a heat rise or loss the sensor will activate the dialer to alert the proper parties. The sensor's range  is from -20 degrees to 110 degrees F and may be adjusted to the high and low  temperatures you require.

WIRELESS DOOR CONTACTS

The wireless door contacts may be mounted on any door and will activate the dialer when the door is opened. The contacts, which use a 9 volt battery, work well with the dialer because they make full use of entry and exit delay on the dialer.

WIRELESS HANDHELD TRANSMITTER

This small transmitter , which uses  a 9 volt battery, can be carried in a pocket or purse. It can activate dialer up to 300 feet away. It may also be used as a panic button to summon for help for those store with limited security that operate late hours, such as convenience stores.

SIREN

The 12 volt DC siren can be plugged into the dialer and will sound  when activated. The siren is designed for exterior us and could be used to scare off an intruder. 120 DB

TIMER/ LIGHT CONTROL

The timer control , when activated by our wireless drive alert, is normally used for security reasons. It has the ability to turn on lights, bells, horns, etc that can be set to stay on for 2,5,10 minutes and then will shut off automatically, or you may have the light, etc . turn on until manually reset The control unit has an on/off switch for use your convenience. Installation is very easy- just connect the timer to the dry contacts on the receiver and plug in the light. The timer control can turn on up to 250 watts of light.

LOUD RINGING BELL

This 6" bell can be used with any of the driveway alarms. It can be used outside or inside for people with hearing problems. When used in conjunction with the light/timer control it may be programmed to ring up to one hour.

LINE CARRIERS

These are designed to send a remote signal from one building to another, providing that all locations are downstream from one power transformer. Plug the transmitter into a 110 volt outlet in one building, and throughout your existing power lines, it will trip the receiver in another building. The transmitter can be activated by a driveway alarm. A loud bell or light plugged into the receiver would be activated.

 

        LINE CARRIER $84.95

 

 

LINE DRIVER	Sends signal through AC wiring Connects to any of our driveway alarms Switches lights, sirens, chimes, etc. Flashes lights in the house Plug in the line driver and it's ready! Use with remote chime, light switch
LINE DRIVER  $49.95

	Line Receiver Module $39.95
	Line driver is required for operation Unlimited amount can be used Switch lamps or sirens through AC 300 watts max. or Heavier Duty: 500 watts Easy add-on, just plugs in
LINE RECEIVER MODULE $39.95

	Remote Chime$39.95
	Chimes to any room or outbuilding Uses existing AC wiring Line driver required to run remote chime Unlimited number of chimes may be used Great for other buildings
REMOTE CHIME  $39.95

 

	STROBE
This strobe can be used for the hearing impaired as well for use in noisy environments. The amber color is best suited for this purpose. The strobe has a flash rate of 90 flashes per minute.           STROBE $49.95

 

 

This Motion-Activated Light Control requires no wiring. It is ideal for chasing away prowlers and intruders as well as improving nighttime convenience and safety. When a dark room or an outside area the sensor is monitoring is approached, a light will go on automatically for a period of five minutes and then shut off. The wireless motion sensor is weather sealed for long life and activates the plug-in receive from up to 100' away, with the signal passing through doors, walls and floors. An override feature allows you to turn lights on and leave them on. Requires 4 AA alkaline batteries, (not included).

Wireless Motion-Activated Light Control Transmits to 100 feet away Turns a light on for five minutes Keep prowlers away or you will not have to search  for the light switch in the dark. Operates independently of driveway alarm

Wireless Motion-Activated Light Control $49.95

You are visitor: